Search results

  1. S

    Pentair IC20 salt cell replacement

    Hello everyone! Haven't posted for a while, since our pool has been running "Trouble Free" for a few years. Approaching 7 years on our original equipment, so I was looking at picking up a replacement salt cell for the inevitable failure. Can I use an IC40 replacement cell in my system? Cost is...
  2. S

    Pucks in the early season?

    13k gallon pool, with SWG. I usually drain below the skimmer level in the fall when closing, then refill with either rainwater or municipal water in the spring when opening. This always leaves me with a bit of a CYA deficit (usually aim for CYA of around 60-70). Does anyone use pucks in the...
  3. S

    Filter Cartridge Care and Lifespan

    Hi All! Thank you for our second season of trouble free pool care. So happy I found this site when our install was taking place. Water has been absolutely sparkling for two solid seasons. WooHoo!!! As I'm preparing to close in the next couple weeks, I pulled my filter apart today and hosed off...
  4. S

    Just opened to clear water--Thank you TFP!!!

    Closed in October (solid safety cover) with the water temp around 55F by adding my remaining 2 gallons of 10% bleach. Just opened this week to a water temp of 50F, after following the TFP method last year with our new fiberglass pool. Many thanks to the moderators and all the contributors here...
  5. S

    IntelliFloVS pump program...is this a logical setup?

    Hi All, New pool installed last fall, opened this spring. PB installed an IntellifloVS pump at my request. When the electrician wired the panel, he ran the pump off its own breaker. The SWG and HeatPump are both connected to the Intermatic mechanical timer supplied in the breaker box. I...
  6. S

    Finding optimal TA

    So I started this season opening with my TA=150. Over the last 2 days, I have been incrementally adding Muriatic Acid to bring the pH down to 7.0-7.2, then aerating with my tile-line fountain jets. After my last addition of acid, I have a pH of 7.2 and TA=110. I'm planning to continue until my...
  7. S

    At what point is it safe to be in the water?

    New pool owner here--thanks to all for the advice so far. At what point after opening in the spring is it safe to be in your water? Assuming the water is clear, do you wait to see any specific testing parameters over a period of time before using the pool? Or is it safe to be in once pH and FC...
  8. S

    New Opening--here's my numbers (why didn't TA change?)

    Hi All! New installation started last fall--IG Viking Coronado (15' x 34'). Been reading on this site all winter in anticipation of taking care of our new pool. Thanks for everyone for sharing their knowledge and expertise. The fence and sod were put in 3 weeks ago, wife and I have been...
  9. S

    New pool installation--starting from scratch

    Hi All, Finally broke ground today on our new pool installation--just a couple quick questions about the TFPC method when starting from scratch. I have a TF-100 on order. Pool is an IG Fiberglass Viking Coronado, 13000 gallons, Pentair Intelliflo VS pump, Pentair Cartridge filter (320)...
  10. S

    New Pool Installation

    Hi All, Just signed a contract this week, with the hopes of our new fiberglass pool being installed this fall. I would imagine swim season will be over here in the northeast by the time it's done, so the installer will winterize and cover once it's done. I've been lurking here for a couple...