Search results

Thanks!

Hi, What do you all recommend to remove this white film on my pool tile?

Thank you everybody did try to clean it with alcohol only to also find out that the propeller motor was also rusted and now does not work.. time for a new robot.. sad to see this one die. cost of new motor is $300. problem is Marina is out of the pentair warrior SI that would have been comparable..

Yes, tried calling them but no answer today. Will try again tomorrow morning.

Cannot find this PCB board anywhere options: buy new robot or attempt to fix?

Hi, Active 30i stopped working today. It starts and goes in reverse for about 5 seconds then forward for about 5 seconds then stops working. LED also stopped flashing. About 4 years old recently replaced the cord. Decided to open up the motor and found water in the unit both motors still work...

Thank you Jim and ajw22! Got it working!

Sorry not sure why its not working as it trips the GFCI as soon as I turn on the relay on ET. here is a picture of my GFCI. Using the top left Hot to relay #1, #2 from relay coming back to light transformer. For the White Line cable using the bottom right as that is the "Line White", also...

I have it going to to low voltage transformer and back to the GFCI outlet. I also ran a ground wire back to the panel to the low voltage transformer. hope that helps.

Jim, Thanks, got that switch and worked to get load out of pin 2, now when I turn on the relay it pops the GFCI outlet. How should I wire the Line (White) straight from the outlet? or how can I stop the trip?

Let me give this a try again - hopefully this picture helps on what I did - I'm also good if you tell me how to wire :). Thanks.

Hi, Looking for some help as I'm putting in some low voltage lighting in my backyard and would like to use the ET8 to automate the lights. Using AUX 4 relay on the right hand side. Planning on using the GFCI power outlet on the power box. I ran the another wire from the hot on the outlet to...

Thanks, mostly dark green mud like stuff. I did purchase citric acid and poured it in las night after letting the FC drop to 1.0. Today it’s at 0 so pouring in chlorine.

Here a picture of the filters

Hi, Looking for help in identifying the following stains in my pool. Pool is white plaster and stains look like Aqua Color stains thorught the pool at this point. Water Measurements: FC - 7.0 PH - 7.2 TA - 70 CH - 475 CYA - 35 Salt - 3350 Temp - 77 I did put in a Vitamin C in the stain...

S300 gets stuck alot as well.. frustrating

Recomend 2.

Look at my build.. did 30"

Yes the weir will take care of your problem.

Currently there are rebates by registering and using the following codes.