Howdy, I have an old Hayward Super II that’s just completely wore out. Started leaking on the shaft seal, but when pulling it apart to repair, it was clear that it’s pretty much at end of life. Had a guy come out to look at it, but figured I might as well just tackle this one on my own and be done with it.
Pool is about 10,000 gallons with spa and waterfalls… maybe about 3 feet elevated from equipment pad to main pool fill.
Currently has 60sf Hayward DE filter, and Polaris sport cleaner with booster pump. Control system is Jandy Aqualink retrofitted sometime after pool was built, but unknown when, before 2017.
Existing pump is 2.25 single speed motor.
The water falls are on a second 1hp pump. Looks like both are 110v. I’m happy to go with a single speed pump again, but if that isn’t an option I’d like to get a big enough variable to eventually remove the second pump and run all through one.
I’m going to DIY this and would appreciate the help making sure I get the right one.
Pool is about 10,000 gallons with spa and waterfalls… maybe about 3 feet elevated from equipment pad to main pool fill.
Currently has 60sf Hayward DE filter, and Polaris sport cleaner with booster pump. Control system is Jandy Aqualink retrofitted sometime after pool was built, but unknown when, before 2017.
Existing pump is 2.25 single speed motor.
The water falls are on a second 1hp pump. Looks like both are 110v. I’m happy to go with a single speed pump again, but if that isn’t an option I’d like to get a big enough variable to eventually remove the second pump and run all through one.
I’m going to DIY this and would appreciate the help making sure I get the right one.
