Recent content by wanjayne

Thank you for the information! I’ve forwarded this to my son to familiarize himself with the method.

Can’t thank you all enough for sharing your knowledge and advice here. We’re going to get start getting the water cleared up so the leak detection can begin. I’ll post again once we’re at that point.

The attached photo shows the water line right after we removed the cover. The light niches were still under water at this point. Did we jump the gun by removing the winter plugs and allowing the water into the pipes? Should we cap all the intakes and returns and let the leak continue until it...

We just removed cover and in the process of adding water to begin opening process of testing, treating, clearing, balancing etc. It became obvious we’ve got a leak somewhere. We’ve not started the system yet so Pretty sure it’s in the liner, but honestly, I don’t have a clue where to start...

Disregard my previous post….. I just attempted successfully to move the thing to my desired selection of 20% every hour. Apparently the interpretation of all the various light messages is a bit out of my wheelhouse….. Like so many technical things are for me these days. So relieved it appears...

The problem I ran into is that I’m unable to cancel the boost mode. I’ve followed the instructions by pressing more and less buttons at the same time. The lights will just change from simultaneous flashing to left to right flashing. They will not return to stationary green light at my choice of...

I’ve had no luck stopping this and have no idea what it means. I’ve held less and more buttons and it will only change to flashing green left to right or all flashing green at the same time. Cell is only a few years old. Please share your advice.

FC - .5 CC - 1.0 Starting today with the liquid chlorine. From other threads It's my understanding I shouldn't connect SWG yet. I added salt before I read that I shouldn't do that either. Can you tell me what FC number I should be aiming for so I knw how much to add? Thanks for reading my post!

I bet the news crew may have been interested in the mosquito breeding ground you're dealing with when they were imploring folks to get rid of standing water! Neighbors wouldn't have been happy, but they should be ashamed of themselves

:party:We have prime!!!!!! The culprit was the pipe going directly into front of the pump!! OH what a AWESOME feeling.. to see water coming out of the returns!!! Once that section was removed and replaced, she primed within seconds. Pressure gauge on filter shows 15 psi. Now we can add salt...

Skimmers definitely aren't plugged or obstructed. Will make sure check valve is installed correctly tomorrow. Thank you James

Filter is Pentair Clean & Clear Plus 420. Line from pump does go into top port. Here's another photo.

This was a photo taken a few days ago. Just wanted to show the equipment and layout in the event a photo may help.