Recent content by tommytuna

I just got off with Hayward support - really nice guy. Unfortunately he had me try a few thigns and came to conclusion that the LCD needs replacement. WIth older firmware there is no other way to force the calibration procedure other then hopping through the menus. the bottom part of my screen...

ALl good - i found an old thread on this and some folks said they had to replace the LCD. I'm wondering if just the LCD replacement ($100) part will fix this or if you also have to replace the entire computer. Hayward posted a doc here - seems like a simple enough switch with no impact to any...

Does anyone know if the $100 screen replacement part would fix this touchscreen issue?

Thx appreciate it!

Hi all - in the four years of owning the Omnilogic i've had to calibrate the touch screen twice using the procedure found on their site -> Config -> Shell https://hayward-pool-assets.com/assets/documents/pools/pdf/troubleshooting-guides/omnilogic-how-to-guide.pdf?fromCDN=true However this year...

I have a new pool going in with an omnilogic system and Intelliflo XF pump. We can't find documentation anywhere on how to hookup the Intelliflo to omnilogic so that it will control the speeds... I have the black com cable that came with Intelliflo and some documentation vaguely mentions using...

Spoke to local Pentair rep. He is puzzled and thinks it may be a bad batch of seals. He is ordering another pump from a totally different batch. It looks like the pumps I got were all part of the same batch. He didn't really push back and was quite helpful so we'll see where this goes. The...

more pics

Last night I had a closer look at the original pump that leaked (Pentair left it behind). See pictures attached. Shaft looks perfect (no rust) but you can see the on the plastic flange(sp?) where the water was dribbling down on the motor side (little salt water crust trail on last pic). I don't...

My wiring is attached in the pic below. Electrician did it so I never questioned it. Everything bonded to the other equipment. I pulled apart the second pump they gave me (Pentair never picked it up). Looked at the shaft on that unit and it looks perfect without any corrosion. I'll try to take...