Recent content by tom70

James - thank you! As you were writing the messages about ORP it was making sense that since the value has not dropped below the set-point, the SWG does not need to produce anything. Hence the cell light would be off. I appreciate everything as I was just figuring that I would be looking to...

Intellichem set value is 700.

704 ORP

Correct the IntelliChem controls the SWG. So I am guessing that because of the chlorine level being higher that the cell if off due to that no chlorine is required. I just never noticed it ever being off that I recall, but it could be. The good thing is that my pool is always crystal clear...

I would think everything is the same as nothing has changed. Something I should look for?

When I do that the lights scroll on the bottom (left to right) and then light up from the bottom up: flow / cell / cold water / low / good showing the lights all work. It then blinks green on the cell and flow light simultaneously. Then it shows the solid GOOD (salt level light) and solid FLOW...

When I open my pool I always put a chlorine floater in until the water gets warm enough for the Pentair IC40 to take control. Also, the cold water light was on on the IC40 unit hence the reason I put the floater in. As of the last two weeks I noticed the cold water light off so I pulled the...

I will do this first indeed (possibly tonight if I feel motivated after work).

Yes 4-conductor as it just needs 4-wires. thanks for the info!

So I woke up this morning thinking that since I had disconnected the Indoor Control panel connection from the indoor unit and the problem still arose until I removed the wire at the outdoor panel, that would probably mean the wiring is indeed bad. Where is a good place to purchase this wire...

Tom/Dirk- When I got home from my office I decided to tackle this issue. With the power off I disconnected the Pentair Spa Command wiring first and powered up. Same issue, so I then disconnected the Pentair Indoor Control. Powered up and everything works as it should! The problem was indeed...

Thanks for the input. I should have the time this weekend to officially start removing devices and checking wires. I appreciate all of this help!

I disconnected everything except the pump and it said "DISPLAY NOT ACTIVE"!!! So now with the "cluster" of wires I have I now have to figure out what could be causing it. I added wires back and there is a black and red wire that you will see not connected to the COM port. The problem is that...