Recent content by TEXASERIC

The opposite direction is where it splits out the flow. Still seems strange it would have that much effect downstream of everything

So I just hit the override on the pool/spa swap over valve and the heater fired. Only thing is, is the override sends everything to spaso my spa waterfall into pool is kicking lol. But I am taking suction from pool and going through Beater and back to pool via spa overflow so it will get me there

Correct, the pool temp dropped to 80 overnight. Thank you for all your help.

Only temp sensor is on pump discharge. It is same pump regardless of pool or spa mode

Also you can't see in the other pics but the heat light is illuminated on the panel outside and the app shows the pool heating active. I do have an auto valve that stay in a mid position to allow spa overflow but it is downstream of pump/heater so should not have a negative impact to total flow...

It's an app on my phone

Pool is 83 trying to get it to about 88. Fixing to try it again.

So I have a Jandy jx400n heater on my in ground pool/spa combo. It is 100 percent automated. My question is do I have to do anything special to heat the pool? I placed in pool mode and pool heat on and it said heating in the app but the heater never fired. I can place in spa mode and spa heat...

The breaker reset worked but then went screwy all day today. This thing worked flawlessly for 5 weeks following completion of my pool, but now is like junk. I wish I had the old hand held from the pool at my last house.