Recent content by SPKNout4CHRIST

If I push the pump back to have 11” of pipe, can I have more direct pipe on the pressure side? I didn’t see anything in the manual about minimum pipe on the pressure side.

It looks like they want 10” of pipe leading into the pump. Well this pump inlet is lower than my old one, so I’m going to have to 90 it twice to drop it to the right height. Should I do a 90 down and then 90 towards the pump and go 10” from there to the suction inlet? That puts the pressure...

Confirmed that a 2” union fits on the provided union. Thanks fellas!

I think so. Headed to Lowes with it now to make sure.

Do I simply get a union and join their union with my existing pipe by cutting the end of pipe I’m holding?

Okay, I’m missing something. It appears my SuperFlo has 1.5” inlets/outlets. My pipe is 2”. It came with a union kit 1.5” 351157. How do I use that, if at all, to connect this pump to my 2” pipe? Thanks!

Can you link me to the appropriate wire? Having trouble finding it. Only need 15ft, but know I may have to get at least 25’. I believe this is the breaker: Siemens QF220A QF220 Ground Fault Circuit Interrupter, 20 Amp, 2 Pole, 120 Volt, 10,000 AIC, Color...

I am wiring it to 240.

I am replacing my single speed pump with a VS pump. I know I need to add a GFCI breaker, but my question is where is the best place to put it? Should I put it in the sub panel on the left or should I replace a breaker in the panel on the right, if it would even fit there? I don’t use the...