Recent content by Rmf1981

@mknauss any other suggestions?

Initially had it on boost (100% for 24h). With appropriate levels as of 36 hours ago turned it down to 50%. Edit: 75% x 12 hours

Hi @mknauss. Took your advice and added liquid chlorine. Per the instructions, we were able to get a free level of three. Continued with the SWG. Unfortunately, now about 36 hours later showing no free chlorine again. Stabilizer also looks a bit low. Would that be the cause of no...

Got it, thank you

Well, just to close the loop here, I ended up ordering a new salt cell. Upon further inspection of the old one, the central plate does seem to be somewhat degraded. It's certainly not gone entirely, but it's quite jagged at the end. I don't know the age but my estimate is that it's at least...

Anyone have any other suggestions? Either this is an issue no one has ever seen, or I"m not explaining it righ t.... For what it's worth and for future reference - a few additional things I have learned: There is no front and back board anymore. Jandy replaced the front/back board setup...

Sorry, I don't have an answer to your question but I did want to say "Go Irish!"

Were you getting a no-flow error?

Hi all - So I received the replacement board (back board I believe .... R0467600) and reinstalled it this morning. Good news is that my previous error codes are now gone (125/194). Bad news is that I have two new error codes to replace them! (170/193). Reading through the tech manual...

Interesting. So if this is the rear PCB, where is the front PCB? I do not see another board. In looking at the workbook, it seems to me The front / rear board configuration must have been an older configuration. It is listed as such in the workbook. The board referenced first in the workbook...

Hi All - hoping for a little help diagnosing my salt water generator system. I've done as much troubleshooting as I can and getting some confusing results. I have the Jandy Aqualink connecting to a Zenith Nature2 Fusionsoft 1400 SWG. My wife, primary caretaker of the pool, noted to me she was...

Thanks @Mdragger88. I will look into that. So I ran it without the filter overnight, to see if I could replicate the FL-1 error again. When I inspected the tub this morning, temperature was fine and the waterfall was running as expected. Upon starting the jets however, The FL-1 error returned...