Recent content by mjolsen74

First I removed all potential for power to the lights. completely disconnected in junction box too. I unscrewed light from wall can and pulled out to deck with about 2 foot out of water. Cut the cord at the light so I had enough to tape about 12" with duct tape tightly so it would fit the...

Solved.. Check my post in the other thread: ColorLogic lights with Omni hope it helps.. let me know if I can answer anything. mike

BAM! OmniDirect Lights installed and working as described: ok.. I found a local hayward dealer and ended up buying: LSCUS11050 (50') Spa LPCUS11050 (50') Pool Both had a blue label on the outside (3x5 label with serial# and part #). So this confirms what was stated on this forum about...

@PoolBrews - Is this documented anywhere? The OmniLogic relays are all High Voltage, and the low are 24v for actuators or heaters. Everything I've read, you still need a transformer and use the MAIN RELAY BANK to connect from OMniLogic to transformer , transformer to light. My local pool...

@davidl81 , @Kerutuk -- Do you have any wiring diagrams that came with the lights? I have 120v with transformers, but replacing with the 14v OmniDirect. Do I wire both lights to two relay banks directly? Curious how you sync two lights with this new method. Thanks, mike

any updates on this? I am looking to replace my lights now as they are both not properly working. I have transformers for both that then go to the MPP OmniLogic panel. What lights (model#'s) do I need for omniDirect and is there anything out there for wiring diagrams, setup instructions?

very curious of the same.. I have the ColorLogic switched lights, 4 years old and am curious if these work with the directMode. From what I read on the firmware pages you have to be connected to the main panel relay NOT the relay BANK add-ons. I am currently on the relay banks and will have...

any updates on this? I can't really find any good info. I have latest firmware installed and curious if anyone has enabled existing ColorLogic to be omniDirect. I went into setup and it asked to test for omnidirect but my lights are on the relay bank and the requirement is to be on Main...

I have the color logic from a few years ago (pool built in 2015) and they are acting up. Sometimes work and sometimes don't. Haven't had the time to mess much with it but right along with the OmniLogic LCD and MSP I think these are total junk. I've replaced LCD and MSP three times in 5 years...

The issue was a different fuse was blown ( not the actuator fuse). This system is very easy to program as I was able to help the PB program the flow switch and SWG. I've since programed my deckJet LEDs. The UI on web/iphone/ipad works great and very easy to schedule and control. I have...

UPDATE: Hayward reached out to me and did an amazing job! Kudos to Kris and Hayward! They were able to resolve all issues and set the proper programming. This system programmed correctly is great and my heater is working perfect now too. Thanks again, Mike

Just had my pool finished after a grooling 7 months (PB nightmare). To my advantage(or not), I was able to get the OmniLogic system. PB doesn't really know how to program and it sat for three weeks unprogrammed. PB showed up this past weekend after much harassment to program but can't get...

Just finished my pool with pavers. I sealed my driveway and it looks great ( wet look) but it is more slick when it gets wet so I am a little nervous around the pool area. I am currently debating Polymeric Sand and looking for the best one to use for pool areas. I used the Home Depot...