Recent content by mifirecop

No work has been done to the motor. No wiring has changed since it ran all last winter. It ran for a couple hours last week when I opened it. Since the 1st post, I have now disconnected everything from the GFCI and it still trips. Guessing my wallet is headed to the store.

Have not changed any wiring. Replaced disconnect last year and used tub all winter. We have a pool so I dont run it in the summer. It was running a few days ago (on high only) with no issues. Came back to find it tripped and it continues to trip. I have unplugged motor, heater, light, and Ozone...

Hello all! I have had to replace either the start and run capacitor nearly every year. The pump started running on high only when I decided to close it this spring. I just filled the tub and confirmed that it was still only running on high. While letting it run for a while to add some pipe...

I am interested in affixing LED strip lighting to my coping around the pool. I had fiber optic lights there once but no adhesive silicone or even 3M emblem tape could keep it in place once chlorinated water made contact with it. I am wondering if anyone has done or seen this. I'm afraid that...

Thanks for the reply. I dont have any water, only air behind the liner.

We have not pumped any water out. We have had a slow leak for years and would add water once a week or so. I believe it is in the bottom drain return line within a couple feet of the surface. I do not see any damage in the liner to where it is exposed. I have been told if I wait until a 80+...

I have an 18x36 in-ground which we did not open last year. As I pull back the cover I found that the liner has pulled away from the shallow end wall and there is air between the wall and liner. (see photo) Will this stretch back? The liner is about 8 years old. Do I need to vacuum the air out as...