Recent content by jd3073

Good question - I should have included in my initial troubleshooting steps, I did turn off main breaker feeding pool power panel, killing power for a couple of minutes, rebooting the panel. I have yet to press the "reset" button on the RS panel as I'm not sure if that would require...

Yes, I manually selected Service or Time Out and the other buttons do not work. Only Service or Time Out buttons respond. Odd that iAqualink selections result in normal relay operation so it appears the wiring and relays remain operational.

This morning I've confirmed the only buttons on my RS panel that respond are Service and Time Out. Pressing any of the other buttons regardless of Auto, Service or Time Out mode results in nothing (no relay clicking, no lights, no response.) Operating same functions from internal display or...

thank you - I'll go back in the morning and double check and see if they are responsive in Time out. I'm pretty sure none of the relays were triggered in Service mode. Thank you for responding - appreciate your insight.

it did work before - I could start the jet motor when in auto mode.

Yes - I have it in service mode and buttons do not respond, previously they did. I've also tried the buttons in Auto mode and unresponsive as well. So when I finish cleaning the pump (with RS in service mode), then switch back to auto, I'm unable to start the pump or jet motors unless I use the...

Hi - I have an Aqualink RS panel at the pool equipment and indoor panel and remote access via iAqualink. Here's the issue - iAqualink (remote App) controls all the panel function (pump, heater, solar, lights, etc) but when I try to use the actual RS panel everything is wired to, only the...