Recent content by Hammer49

I’m using a Hayward AquaLogic SWGA system, PS-PL-8 keypad and GLX-PCB-MAIN board. Question, using a single speed pump motor, is it possible to have more than two filter timeclocks per 24 hour period? Thanks in advance!

Thanks again for the guidance. The water temperature is displayed accurately. The system was installed in 2007 but the AquaLogic board is a replacement board. The original board was fried by lightning last year. The new one was purchased used. It seemed to work fine until recently, but...

Thanks for the recommendation. I checked the water temp and it is in the 80’s. This is obviously a strange problem. There’s power to the unit at all times, but it’s like the control board keeps changing. Perhaps a bad relay switch?

Has anyone experienced the Aqualogic system actually turning the pump on without being programmed to do so?

Thanks for encouraging the re-check. Using the test kit, Total Alk is 70 and PH is 7.8.

I’ll confirm the chemistry. I have a test kit but was referring to the test strip results from this morning. I’m still having trouble finding bleach, so I was going to dilute cal-hypo before adding it. I was also going to remove the salt cell (using the old one) during the SLAM to prevent...

Hello everyone! Sorry to have my initial post to have so much trouble, but I find myself in a very bad spot. I have a 22,000 gallon pebble tec, SWG pool. Well, when COVID-19 was hitting in March, my T-15 cell quit working. I ordered a new one but it took a week or so to be delivered. And...

Roger that and thanks!

Sorry that I forgot to mention that I do have continuity across the fuses. The system is +/- 10 years old.

Chris- Roger that! I’ll get the specifics. I know it is a Goldline Aqua Logic, Prologic...but will retrieve the model number shortly. Again, thanks for your guidance.

Roger that. Understood and thanks for the guidance!

Yes...sorry, I did mean volts. I get 23.4 volts across the yellow connects but only 0.3 volts across the orange. I’m going to try and attach the pics. I also tested the black and red (upper right hand corner of the board) and got 0.0 volts. Thanks again!