Recent content by Dixit

Yea I do. I have a four button controller on there. I haven’t disconnected that yet to rule that out. I did see some posts about people saying that goes bad and causes it to go in. But here’s why I initially ruled it out, mainly because the main panel even RS8 keypad doesn’t show anything is...

Anyone every seen this? I have an iAqualink and have a Jandy ePump (VSSHP270). My iAqualink is hardwired (not using the Wifi antenna). Lately last few days to a week now Ive noticed my ePump is running ful, tilt. But here is the MAIN issue. The RS8 keypad shows nothing is on, the iAqualink...

Some further info. Today was checking it, been running for like 5days now, and still same amount of air, so that tells me nothing leaking on the vacuum side. So I have an infloor cleaner popups as noted in my signature and the leaf be gone system. So today decided to turn the waterfall on...

Only saw that initially obviously cause the lid was off and air was entered into the system. But not seeing any bubbles or anything odd in by system. Well its god to know you are seeing the same issue. Im assuming you still have the same issue with that much air in the system? Dixit

I had originally on this setup a Sta-Rite Max E Pro 2hp single speed pump, working fine, no issues with it, no air in the basket, worked fine. Just ended up getting a great deal on this Jandy ePump VSSHP270AUT model. So we went ahead and installed it. Now the Sta-Rite doesn't match piping so...

Then again that PDF is also somewhat confusing, cause step8 talks about the wrench, but step9 says if you have deluxe series you just hand tighten it. Then on that same page, it seems I have the deluxe series since all mine look exactly like those, with the scallops on the bezel, where the...

Thanks, I definitely have two of the pulsator (216-6070) and two of the adjustable rotors (210-6090), and also got two more of these other types that I don't see listed here, but it has like 7 holes in there (Massage one, I think its a 210-6700 according to the site). But regardless it mentions...

Not sure how to tell who the manufacturer is. I want to say must be Polaris or Jandy since everything in my pool had been mainly that with the exception of the lights were Pentair. I know they can be turned left to open the jet fully and right to turn them off. That's the only movement by...

I have a few that don't spin properly under load. Tried to turn it left as hard as I can and not seeing it comes loose. Not a lot of room to grab it with the pool surface digging into my hands. Anyone know how to remove these so I can purchase new ones? Here is the picture I took off my phone...

And as I knew, Jandy isn't going to help me any further. "At this point I have to suggest having a professional come out onsite to inspect the problem with the Solar JVA. I hope you understand that I want to help you solve this problem but I can’t do so through direct troubleshooting with you...

So asked Jandy support via email, they told me the following "This looks to be a glitch in the firmware. You can clear the memory and start over. This usually does the trick!" So I wrote down all my settings/schedule programs. Cleared the Memory. Before I did anything, went to Assign JVAs and...

Correct, I still haven't figured out how to take back control of the Solar JVA. I doubt Jandy support will help me, anytime I talk to them its always "if you are not a pool contractor, please call one in your area to help you". Which I think is a cop out, I just want to add some JVAs, I don't...