Recent content by Dilbydog

Solved: Closing this out in hopes someone in the future. Issue was the control board behind the control keypad. New $25 board off Amazon corrected the issue.

Ok, I’ve opened up the heater verified 120vac & 24vac at the transformer pin connector at the board, fuses aren’t blown. I’m half way through Haywards troubleshooting guide. Interestingly , after cycling the breaker the panel service light and the display are rapidly flashing. The display is...

Hi All, Via a little more troubleshooting and research I've eliminated the EasyTouch as the issue. I am able to measure 24vac when the panel is not commanding heat and 0vac when the panel is commanding heat. I can perform a continuity test if necessary, however the conductor between the panel...

Hi, DW wanted to use the spa today, however the heater failed to fire after putting the system in “SPA“ mode. So far, I have: - Verified sufficiently high set point for spa temp - Verified app and panel indicated heat was being commanded - Manually turned on heater; verified fan, ignition and...

Marty, This did it. I had my adapter on my IOT VLAN, I had switched it over to the main LAN to see if I could get access but was still blocked. I then rebooted the adapter so it would release the VLAN IP and grab the main LAN IP and I was able to access locally and remove the password...

ajw22 - Can they reset my password or am I looking at a full factory reset of the entire system? I take it Pentair customer service isn't available on the weekends?

After setting the password in the Screenlogic setup on my PC I also lost access from my mobile devices, so I’m confident that the password is stored somewhere with Pentair.

Marty, Unfortunately I got into this whole mess using the ScreenLogic Connect program from my PC. That is what I am now locked out of. App doesn't work either, but that because I can't duplicate the password.

Unfortunately the password option at the panel is only to setup a 4 digit numeric code. So no luck.

Let me check to see if I can access it from the panel.

Via Local from the app? I’ve never been able to get that to work. My only access has been through remote.

Hello... in setting up my PC access via ScreenLogic connect I must have fat fingered the password because I can no longer login to ScreenLogic Connect. The system has worked for months and I was screwing around in the interface and decided to setup a password. Apparently I fat fingered the...

Anything you don’t like about the Pentair system? Is your controller accessible via WiFi?

Chiefwej… thanks for the response. That was one of my concerns, if I removed the valve body, would be enough pressure to for the pop-ups to “pop” without running the pump at high speed constantly. May I ask your run schedule and RPM’s? Did you leave the nozzles in your pop-ups when you pulled...