cmiller73's latest activity
-
Ccmiller73 replied to the thread Heater settings.To be fair, I didn't know the difference between ET and IC at the time. I never had a system like this. Guess I should have done a bit...
-
CIt is disappointing that installers are selling obsolete EasyTouch systems when the IntelliCenter is available. And that they do not...
-
CThe heater puts out a fixed amount of BTU's regardless of water flow rate. Faster flow gives you the feeling of lower exit water...
-
Ccmiller73 replied to the thread Heater settings.Here is how my panel is wired. Yes pump/IC is on Aux2, but behind mb the connections are swapped with 1 & 2. And, @ajw22 , as you can...
-
-
Ccmiller73 replied to the thread Heater settings.Yes. I have. User manual says 40gpm min. I have my pump set just above that. So at this time, if pump/IC circuit is on, I can turn on...
-
Ccmiller73 replied to the thread Heater settings.I appreciate all the info and advice.
-
Ccmiller73 replied to the thread Heater settings.I may be missing something in the SLconfig, but everything I have tried, will not allow heater to trigger pump circuit. Matter of fact...
-
Ccmiller73 replied to the thread Heater settings.That I understand from a safety standpoint. However, if nothing is running and I decide to turn on heater, why can't it tell the system...
-
Ccmiller73 replied to the thread Heater settings.Will look at that GFCI info and change out. Just have to double check to make sure I don't have one. I'm pretty sure I do not. Only one...
-
Ccmiller73 replied to the thread Heater settings.
-
Ccmiller73 replied to the thread Heater settings.So I tie a jumper directly into the "load line" for the pump relay. Not #2 side as it is now. That was the only way chlorinator gets...
-
-
Ccmiller73 replied to the thread Heater settings.Gonna have to see how it is wired again and then try to understand what you mean. Would no "load" go to aux3 relay? Just "line"? That...
-
Ccmiller73 replied to the thread Heater settings.Doing a bit of digging and reading, I did run across this. "The IC40's transformer must be wired to the load side of the pump filter...
-
Ccmiller73 replied to the thread Heater settings.Kinda messed around with the setup on my phone. As you can see the new circuit at the bottom "Chlorinator" (which would be on Aux 3...
-
-
Ccmiller73 replied to the thread Heater settings.Thanks for the reply guys. After opening the panel, the only thing that triggers the heater on/off is the com cable that is attached to...
