Recent content by auto

100% Positive, been cleaning it for over 8 years. I will double check on the interlock tabs, but I almost 100% sure

So.... My Intelliflo VSF is blowing the lid off of the pump, I am almost positive that this is during when the booster pump starts creepy. The combination has been working prior to this with no issues. Any thoughts, the google machine did not provide any insight. .

Will take a look at filters, it was just cleaned last August, pressure switch ordered. Thanks for all the help, one of the most knowledgeable sites on the internet.

and it just gave me on PS on LED 1 when the heater shut off. Exhaust temp is good, filter pressure 20-23, and some signs of wasps which I will clean out.

Moved from here. So... Having a similar problem. Heater will turn on, 128, r13, then displays correct temperature. Will display service system light then start to heat. Heats for a while then shuts down, service system led lights again, then goes away, and heater starts. Rinse, repeat. Thoughts?

It is coming on automation is my best guess, but cycling through I could not find a way to shut off the set points. There is a setting for manual I will check that out.

My spa seems to turn on the heater whenever the water temp hits below 40, the set point is 40, I can't seem to go lower on that on temperature. I leave my pump running 24x7x365. Is there a way to disable this?

No cover... Thanks. I probably do not have enough time according to that formula prior to party. Looks like a hot tub only party this time.

Having a party on Jan 1. Anticipated water temp will be 41 degrees..... I am thinking about heating the Pool to about 83. How many hours (20K Pool) should I plan on to reach the temperature? Expected air temp will be 25 degrees

Thanks everyone... power restored, all equipment is good and functioning and just in time.

Thanks.. Thought so, but wanted to ask the bright people. that 220 piece kills my gen options. Anything that would cause the spa to lose a bit of water each day, without the pump running?

Been without power to pool equipment for about a week. It has not been 32 (or colder) for more than an hour. I will have power restored tomorrow afternoon (thank God) any damage potential? Anything I should do to minimize re-start?

Which valve is the confusing part, not exactly labeled well.

Of course the genius pool builder did not provide enough electrical slack to change the light with a full spa and need to drop the water level a bit. What is the correct process.... Nothing super clear at this point.. Pic of equip below.

Well... The local Costco has stopped carrying the 3 packs of 8.25 and any other bleach for that matter and only carry the Clorox line of pool products... Ughhh. Anyone know anywhere locally that sells the 8.25 in the 3 Pack? Close to Northpark is preferred.:D