Just wondering if anyone has had any success repairing a stripped screw Jandy valves. I've been chasing down a suction side leak and found the grease fitting was leaking a bit, but when I went to take the valve apart and grease the O rings I found that one of the screws was stripped. So I'd like to rule that out as part of the suction leak. The valve was installed so tight to another valve and elbows that if I replace it I'd have to replace two valves and three elbows. My thoughts are either try to fill the hole with Gflex epoxy which will bind plasics, then drill and tap it, or put an oversized screw in. Anyone that's had success with this problem please tell me how you did it.
Thanks,
Thanks,