OK, I have done tons of searching and am not finding any way to test the motor.
Current status: Turn the power supply on, robot turns on, moves in reverse for about 3 seconds. At that point, everything on the robot turns off. The power supply lights still stays on. When the power turns on for a few seconds the impeller does move for a few secs.
I have checked my plug and get 120v. I have checked power going into the motor (cord and power supply) and it reads about 29v. I have pulled the impeller off to make sure there is nothing blocking it and it turns freely.
Can someone tell me what to do next? Is there a way to test the motor? Is there some water sensor that might not be working?
I did have the robot out of the water Saturday for about 12 hours (I usually leave it in the water 24/7). I think I forgot to turn off the power supply, so it might have tried to run while out of the water. I am not aware of it working after I put it back in the water Sunday.
Current status: Turn the power supply on, robot turns on, moves in reverse for about 3 seconds. At that point, everything on the robot turns off. The power supply lights still stays on. When the power turns on for a few seconds the impeller does move for a few secs.
I have checked my plug and get 120v. I have checked power going into the motor (cord and power supply) and it reads about 29v. I have pulled the impeller off to make sure there is nothing blocking it and it turns freely.
Can someone tell me what to do next? Is there a way to test the motor? Is there some water sensor that might not be working?
I did have the robot out of the water Saturday for about 12 hours (I usually leave it in the water 24/7). I think I forgot to turn off the power supply, so it might have tried to run while out of the water. I am not aware of it working after I put it back in the water Sunday.