Do anyone know if there are caps to go over inground anchors that are used around the pool for the winter covers? I have a travertine paver deck. I would like to find some bronze caps that can go over the holes of the anchors during the summer time so that dirt/debris do not get into them and cause them to be hard to screw back up during the winter time when the cover is to be installed again. Also for aesthetic reasons. Thanks.
winter cover anchor caps?
- Thread starter quantase
- Start date
- Jul 21, 2013
- 52,480
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Never seen caps like that.
Here are the accessories from the two major cover manufacturers:
meycocovers.com
www.looploc.com
Here are the accessories from the two major cover manufacturers:
Accessories
The “best” pool cover should be secure with the “best” hardware. Meyco hardware is non-corrosive, solid brass or stainless steel.
meycocovers.com
Loop-Loc | Consumer Buy Parts
www.looploc.com
Never seen caps like that.
Here are the accessories from the two major cover manufacturers:
Accessories
The “best” pool cover should be secure with the “best” hardware. Meyco hardware is non-corrosive, solid brass or stainless steel.
Loop-Loc | Consumer Buy Parts
Thanks for sharing the link. I will look this over.
- Jul 16, 2012
- 7,206
- Pool Size
- 27000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Hayward Aqua Rite (T-15)
The anchors screw down after removing the cover. There is also collar that you can purchase if the travertine is chipped at all around the anchor, for a nicer appearance.