My builder did not install weir doors on our skimmers, as such skimming is relatively poor and if the pump is off, skimmers empty their junk into the pool. I purchased the appropriate flap that fits my skimmer, but there doesn't seem to be any place to pop the tabs into. Where it looks like there were a place that would be pressed in during installation creating an indention, mortar is filled in behind and has made them ineffective (if I'm seeing what I think I'm seeing). All the instructions for installation I've seen shows simply pressing the door into place and bingo bango. However, a lot of wave action causes my flap to dislodge and get stuck in the skimmer.
Am I seeing this correctly? Has the builder messed this up? Or am I doing something wrong?
Thanks
Am I seeing this correctly? Has the builder messed this up? Or am I doing something wrong?
Thanks