Water Flow LED on, but flow switch is working and flow is good

DrBubbles

Member
Mar 22, 2020
7
Walnut Creek, CA
Pool Size
25000
Surface
Vinyl
Chlorine
Salt Water Generator
SWG Type
CircuPool Edge-40
The Water Flow LED on my Edge-40 comes on about 10 seconds after switching on the SWG. I've tested the flow switch with a multimeter and it is working fine (~zero ohms between the two pins when the pump is on, open circuit when pump is off). It has been working fine for a about a year and a half and I've not snagged the cable or anything. Could it be because the water temp has dropped to ~8C or is this likely a problem with the control cox? (It didn't get this cold last winter). I couldn't find any troubleshooting tips on Circupool site.
 

ajw22

Gold Supporter
TFP Guide
Jul 21, 2013
33,685
Northern NJ
Pool Size
35000
Surface
Plaster
Chlorine
Salt Water Generator
SWG Type
Pentair Intellichlor IC-60
Have you called Circupool support and discussed it with them?

You could have a bad board.
 

DrBubbles

Member
Mar 22, 2020
7
Walnut Creek, CA
Pool Size
25000
Surface
Vinyl
Chlorine
Salt Water Generator
SWG Type
CircuPool Edge-40
The filter pressure was ~15 psi so I cleaned the cartridges and now it is ~10 psi. Still got the water flow led lit though. I've not contacted Circupool yet, will try that next. Thanks.
 
  • Like
Reactions: markayash
Thread Status
Hello , This is an inactive thread. Any new postings here are unlikely to be seen or responded to by other members. You will get much more visibility by Starting A New Thread