Too much chlorine produced

mackay

New member
Jun 6, 2012
3
#1
Hi all,

I have a AquaBlue SWG installed in my pool and have recently come up with a strange problem
FC content goes skyrocketing, well above 3ppm that is no matter where the adjusting dial is set. Have experimented enough, kept the SWG system off for a couple of days, the FC went to zero but two days after running SWG again the FC went over 3ppm.

Anyone have any idea of what could be wrong?

The system is two years old, cell have been cleaned ok, salt level is 3500ppm, pH 7.2

Thanks
 

Bama Rambler

Mod Squad
TFP Expert
LifeTime Supporter
Jun 22, 2009
22,818
SouthWest Alabama
#2
Welcome to TFP.

How long are you running the swcg? Adjusting run time, along with percentage is the best way to adjust the FC you're putting in the pool.

What is your CYA level?
 

mackay

New member
Jun 6, 2012
3
#6
Could run it a bit back lets say 4 hours per day to see if chl changes.
As for the percentage, tt already runs at the lowest possible percentage, can't lower it any more.
The pool is 10000 gallons by the way