So Close...until I noticed that the floating joint had popped. Now draining.


May 9, 2020
Pittsburgh, Pa
After a hair-raising set up of our 16.5 x 9 x 48 oval Intex Prism, the fill was going pretty well. I went into a phone meeting and my oldest took watch, which should have been fine, as he's nineteen, but I came out after the meeting and noticed that one of the floating corner joints is all but popped out of its socket. Complete nightmare. Vigorously draining now, but wondering how far down we'll have to drain to get the wiggle room we need, as I've never dealt with floating joints before. Any ideas? Thanks!
Thread Status
Hello , This is an inactive thread. Any new postings here are unlikely to be seen or responded to by other members. You will get much more visibility by Starting A New Thread