ddarlac

New member
Jun 11, 2021
1
NJ
Hi there,
my heater (Raypak 266) started malfunctioning; basically it lights up, runs fine for 2-5 minutes, then shuts down, the ignitor kicks in - and here is the strange thing, the burners do not light up but on the control screen it shows flame is fine.
If I turn off (using the button), and turn on the same will happen (works fine for a couple of minutes, and then malfunctions).
I checked the water pressure and temperature switches - no problem there; I just changed the inginor/pilot assembly - same problem.
any ideas - suggestions?
thanks,
Dimitris
 
Feb 16, 2021
22
Courtice, Ontario, Canada
Pool Size
13400
Surface
Vinyl
Chlorine
Salt Water Generator
SWG Type
Pentair Intellichlor IC-40
Hi there,
my heater (Raypak 266) started malfunctioning; basically it lights up, runs fine for 2-5 minutes, then shuts down, the ignitor kicks in - and here is the strange thing, the burners do not light up but on the control screen it shows flame is fine.
If I turn off (using the button), and turn on the same will happen (works fine for a couple of minutes, and then malfunctions).
I checked the water pressure and temperature switches - no problem there; I just changed the inginor/pilot assembly - same problem.
any ideas - suggestions?
thanks,
Dimitris
any error codes?
 
Thread Status
Hello , This is an inactive thread. Any new postings here are unlikely to be seen or responded to by other members. You will get much more visibility by Starting A New Thread