PSA: Don't forget to clean your Dolphin impeller

MITBeta

Gold Supporter
May 28, 2020
947
North Attleboro, Massachusetts
Pool Size
13000
Surface
Vinyl
Chlorine
Salt Water Generator
SWG Type
CircuPool RJ-45 Plus
I should have taken pictures!

Take off the two screws on the plate that the cord goes through and remove it and the baffle below it. Unclip the cowling above the impeller. Remove the 4 screws holding the mechanism that controls the direction of water flow to the 3 ports. Remove the screw from the top of the impeller. Notice that the impeller shaft has 2 flat spots on it, so when reassembling make sure to line this up with the impeller before screwing in.
 
Thread Status
Hello , This is an inactive thread. Any new postings here are unlikely to be seen or responded to by other members. You will get much more visibility by Starting A New Thread