Hi! We just finished installing a new 24’ x 54” Wilbar Ventura above ground pool. We worked diligently to get the details perfect. Redoing some steps to ensure near perfect level and perfect round. Everything looked great until we the water level got to around 3/4 of the way full. Approximately 10” below the skimmer. We noticed one area of the wall is bowed out. It is near where the stainless service panel is joined. I hope you can see from the pictures that it is pushing out on the upright. Any insight on what’s causing this would be so helpful.
We did stop adding water and started pumping it out to alleviate the pressure until we fix the issue.
We did stop adding water and started pumping it out to alleviate the pressure until we fix the issue.
Attachments
-
D7AB0BA9-0CF5-48D7-9D06-E333A6335165.jpeg647 KB · Views: 40
-
B10DAC4F-0D60-4109-9EBE-CFAA31185047.jpeg593.4 KB · Views: 38
-
F7A6C62B-5596-472F-8B33-F68B7E96E3A1.jpeg572.8 KB · Views: 38
-
6E2EFC1E-D46B-47A8-8D9E-8E6007036629.jpeg525.4 KB · Views: 37
-
E10257BC-DC10-432E-AB62-9EFA5EE451D9.jpeg570.7 KB · Views: 36