Pool Equipment Pad Wet

[JC1256]

Hi everyone,

We had an inground pool installed back in October 2020. They just came to turn everything on last week and it seems the equipment pad is always wet. I don't see visually anything dripping but it is always wet. I am sure it shouldn't be like this and it could rust things out no? Any input would be great.

Thanks

 

[ajw22]

My guess is the leak is from the filter. But check the drain plugs on the filter and pump for any moisture. Some pool lube on a plug O ring can stop a drip.

Pool Lube - Further Reading

www.troublefreepool.com

 

[YippeeSkippy]

Look on the top of the filter to see if you find a eeny little drip running down the side of the filter from under the Multiport Valve. That might only require tightening, or lube on the gasket within.

Maddie

 

[JC1256]

Thank you. I checked and they seemed good. I am going to have the pool company come out since it was just done.

 

[Andrew_D]

If there is no sign of leaking from anywhere visible, start thinking leaks that you cannot see. First one that comes to my mind is the pump seal.

Andrew

 

[JamesW]

Get a flashlight and look under the pump and towards the front where the seal is to see if you can see a drip.

 

[JC1256]

Thanks - I will check that out for sure. It's hard to see because there isn't much space.

 

[duckcmmndr]

Mine did this last year when I started up the equipment on my brand new pool. I have a Hayward sand filter and it was the drain on the filter that had a tiny drip. Once I tightened it up it was good to go. Be sure and inspect while your pump is running so the system is under pressure.