PDA chlorine % different than Power Center display

[kjmoriarty]

With my pool in "auto" mode, the % chlorine production on my PDA is set to 90%; however, on the Power Center display board, it shows 0%. I've cleaned the salt cell and the tri-sensor. I powered down the system at the breaker and left it off for 5 minutes, then restarted. No change. I replaced the batteries in my PDA. No change. Right now I have my pool in service mode with chlorine set to 90%. What am I missing? Any suggestions?

 

[ajw22]

Let's see what @PoolGate thinks.

 

[PoolGate]

When you are looking at the LCD display on the panel, is the pump running and primed? On a restart, it will show 00% production until the pump is running. It will also say "wait" and the flow light will be off.

 

[kjmoriarty]

Pump is running and primed and past the “wait” period. Still shows 0.0% but on my PDA it’s set to 90%.

 

[PoolGate]

So in service mode it shows correctly? Can you change the percent at the panel?

 

[kjmoriarty]

Yes, I can change the percent at the panel.

 

[PoolGate]

I'm stumped. Try opening a case with Jandy tech support.

 

[kjmoriarty]

I will do that. Thanks!