No power from EasyTouch to Mastertemp 250

TripleTee

New member
Jun 5, 2021
1
New York
Bought a house with a pool. Pentair EasyTouch and Mastertemp 250 heater. Heater is shot due to mice damage. Bought a new heater (same model) and have it plumbed in for water and propane. Wired it and nothing. I disconnected feed (2 red wires) and tested for power. No power even with the heater led on in the easy touch panel. I'm at a loss as to what to test next..
 

Jimrahbe

Mod Squad
TFP Expert
LifeTime Supporter
Jul 7, 2014
22,609
Bedford, TX
T,

Most heaters are wired direct to a circuit breaker and not through any EasyTouch relays.

Step one is to find where the AC power going to the heater comes from..

Thanks,

Jim R.
 
Thread Status
Hello , There was no answer in this thread for more than 60 days.
It can take a long time to get an up-to-date response or contact with relevant users.