New Raypak heater - mode issue

tpan1206

New member
Jul 13, 2021
2
[email protected]
My Raypak which was installed in late June has been in remote mode and i use a Jandy system, this past Saturday after about three hours I heard a pop, went to the unit and the screen asked me to press mode to enable unit. It basically exited remote mode so I had to hold down up and down to place back into remote mode. Any idea what may have caused this? Mind you it was running between 2 and 3 hours.
Apprecaite any insight.

Tom
 

ajw22

Gold Supporter
TFP Guide
Jul 21, 2013
29,041
Northern NJ
Pool Size
35000
Surface
Plaster
Chlorine
Salt Water Generator
SWG Type
Pentair Intellichlor IC-60
Is your heater running properly once you put it back in remote mode?
 
Thread Status
Hello , This is an inactive thread. Any new postings here are unlikely to be seen or responded to by other members. You will get much more visibility by Starting A New Thread