Lights out

miketriton

Member
May 17, 2010
20
I went to turn on my hot tub last night and after a few attempts managed to get it to fire up. I have a Jandy control sytem which doesnt always start the hot tub heater. If I turn off and then turn on at the heater it starts to spark then if I beat on the gas control valve a couple of times eventually it gets going. It seems like it may be a sticky control valve. Is this common?

Of course nothing happens in isolation. I then noticed the pool and hot tub lights were out. I could not switch any on at the hot tub spalink or in the house at the control panel. Could this be a relay in the Jandy link control box?

By the way since I started BBB, absolutely no algae, everyone around me has algae problems, way to go BBB.
 

miketriton

Member
May 17, 2010
20
I figured it out, the lights are wired through a GFCI receptacle, it had tripped. he heater is still a mistery.
 
Thread starter Other Threads of Interest Forum Replies Date
C Everything Else 1
igneous Salt Water Chlorine Generators (SWG) 8
A Everything Else 0

Other Threads of Interest