Good Morning! I have a intelliph that has the plug cut, and trying to figure out what the wires are so I can install it on a jandy control center. It's a 24 volt controller. The wire colors are red, black, white, green. Tia for any help.
Intelliph wiring diagram
- Thread starter LABPS
- Start date
- Jul 21, 2013
- 52,452
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Welcome to TFP.
Which cable has the plug cut out?
The IntelliPH is typically connected to the INTELLICHLOR POWER CENTER. The latest EasyTouch, IntelliTouch Load Center includes a built-in transformer for the IntelliChlor SCG, and no longer requires an IntelliChlor Power Center.
My guess is the red and black wires are for the 24V power and the white and green are for the RS-485 data that the Jandy cannot communicate with anyway.
See Page 9 in https://www.pentair.com/content/dam...on_and_Users_Guide_English_Spanish_French.pdf
Which cable has the plug cut out?
The IntelliPH is typically connected to the INTELLICHLOR POWER CENTER. The latest EasyTouch, IntelliTouch Load Center includes a built-in transformer for the IntelliChlor SCG, and no longer requires an IntelliChlor Power Center.
My guess is the red and black wires are for the 24V power and the white and green are for the RS-485 data that the Jandy cannot communicate with anyway.
See Page 9 in https://www.pentair.com/content/dam...on_and_Users_Guide_English_Spanish_French.pdf