Help reinstalling spa light


New member
Apr 18, 2021
northern california

I am not sure what type of spa light I have, but I removed it trying to fix it. Putting it back in the wall has proved difficult. The light is a pentair light, but the cord is too short to remove it from the water and there is no housing to attach the pilot screw. All I have is the plastered wall and a wedge. My assumption was that the wedge would somehow provide pressure against the plaster, but I can't seem to make that happen. Does anyone have advice? One additional detail is that I am pretty sure the lights are LED lights.

On a stupid side note, turns out I didn't need to remove the light anyways as all that was needed was to reset one the power outlet on the same circuit.

Thanks for any help!
Last edited:


Gold Supporter
TFP Guide
Jul 21, 2013
Northern NJ
Pool Size
Salt Water Generator
SWG Type
Pentair Intellichlor IC-60
Did you try tightening the screw in the wedge?

You see the way it wedges between the light housing and the niche?

  • Like
Reactions: duade
Thread Status
Hello , There was no answer in this thread for more than 60 days.
It can take a long time to get an up-to-date response or contact with relevant users.