Have an AquaCal T115 heat pump. Did not run it during summer months. Getting ready to run it, but noticed the temperature on the display panel is about 10 degrees cooler than temperature on pool thermometer. Does this present an issue I need to consider before running the heat pump? Thanks.
Heat Pump Temperature
- Thread starter Henry M
- Start date
Thanks for your reply. The heat pump display panel temperature reads 74F. The temperature on the SWG display panel reads 83F.
If the water temperature is not accurate, then you probably need a new temperature sensor.
www.inyopools.com
AquaCal WATER TEMPERATURE / DEFROST SENSOR 10K OHMS (STK0021) - 6105D - INYOPools.com
WATER TEMPERATURE / DEFROST SENSOR 10K OHMS - Pool & Spa Parts
www.inyopools.com
I thought as much, but also thought I should check with those who know more about these sort of things than I do. Would you happen to know what the level of difficulty is to replace? Is it a DIY project, or do I need to have a technician do it? Again, many thanks for your help.If the water temperature is not accurate, then you probably need a new temperature sensor.
View attachment 377432
AquaCal WATER TEMPERATURE / DEFROST SENSOR 10K OHMS (STK0021) - 6105D - INYOPools.com
WATER TEMPERATURE / DEFROST SENSOR 10K OHMS - Pool & Spa Parts
View attachment 377433
It should not be too difficult but only you can determine if you feel comfortable doing this type of thing.
Thanks. One last question: do you know where I could find instructions about how to do this?
It should look like this.
One end goes into the thermostat well and the other end connects to the power board.
I think that this is the well.
Remove the rubber cap and take out the sensor.
The sensor should just pull out.
Don't remove the well.
www.inyopools.com
One end goes into the thermostat well and the other end connects to the power board.
I think that this is the well.
Remove the rubber cap and take out the sensor.
The sensor should just pull out.
Don't remove the well.
AquaCal T-STAT SENSOR WELLS PLASTIC (TI UNITS ONLY) - STK1113A - INYOPools.com
T-STAT SENSOR WELLS PLASTIC (TI UNITS ONLY) - Pool & Spa Parts
www.inyopools.com
Last edited:
Many, many thanks!! You've gone above & beyond with the information you've provided. For novices like me, this information is invaluable. Can't thank you enough. Stay well.It should look like this.
One end goes into the thermostat well and the other end connects to the power board.
View attachment 377439
View attachment 377436
View attachment 377437
I think that this is the well.
Remove the rubber cap and take out the sensor.
The sensor should just pull out.
Don't remove the well.
View attachment 377441
View attachment 377442
AquaCal T-STAT SENSOR WELLS PLASTIC (TI UNITS ONLY) - STK1113A - INYOPools.com
T-STAT SENSOR WELLS PLASTIC (TI UNITS ONLY) - Pool & Spa Parts