Moved to a house with an existing pool about 2 weeks ago, first time testing using k-2006 and wanted to get some insight on what to do. I know I can probably find some information, but I'd like some hand holding if possible since it's my first time, I promise I'll be less annoying moving forward
FC = 6.8
CC = 1 (is that ok?)
PH = 7.8
TA = 120 (too high?)
CH = 170 (Apparently I don't need to worry about this at all since I have a vinyl liner)
CSI = ? (If I don't care about CH, do I care about this?)
CYA = 39 (too low?)
SALT = 4000 (seems a bit high)
I lowered the SWG to run at 45% today, it was running at 70% after someone came over and saw that chlorine was low when it was running at only 20%.
Is there anything that jumps out at you that is seriously wrong? What steps should I follow to get everything in good shape?
FC = 6.8
CC = 1 (is that ok?)
PH = 7.8
TA = 120 (too high?)
CH = 170 (Apparently I don't need to worry about this at all since I have a vinyl liner)
CSI = ? (If I don't care about CH, do I care about this?)
CYA = 39 (too low?)
SALT = 4000 (seems a bit high)
I lowered the SWG to run at 45% today, it was running at 70% after someone came over and saw that chlorine was low when it was running at only 20%.
Is there anything that jumps out at you that is seriously wrong? What steps should I follow to get everything in good shape?