Finally started!!!!!

Carnut12

0
LifeTime Supporter
Jun 2, 2013
331
Forsyth, GA
After 2 years of debating getting a pool we finally took the plunge. We started this process 2 years ago, but potential relocations at work delayed it. This year I decided I can't just keep waiting thinking we might relocate, we will cross that bridge if and/or when we get there.

Here are the pool specs-
24'x44' Freeform
Deep End poured concrete Bench
Poured Concrete Steps
Cantilever Edge with stamped border
Unilock Brussels Paver Decking in Sierra, around 1400 Sq Ft
Unilock Brussels Dimensional retaining wall
2 laminar jets
Gerano liner from GLI
Intellitouch 8 with Screen Logic

All Sta-Rite Equipment-
450 Sq Ft Cartridge Filter
400K Natural Gas Heater
Salt Generator
Intellipro Supermax VS Pump

I am sure I missed a few things

Here are a few pictures so far- by the way these pics are taken from the deck off my bedroom, going to be a great view.
20krpzl.jpg


wkjqcn.jpg


35jgl7n.jpg


Everything look OK so far????
 
It's a liner pool with Polymer walls, based on going with Salt I preferred Poly, but I was not anti-steel. I honestly ended up picking the PB I wanted regardless of what type they used.

- - - Updated - - -

This is the manufacturer I went with-

http://www.imperialpools.com/products/polymer-pools
 

Enjoying this content?

Support TFP with a donation.

Give Support
Permit is signed off for the footing, now they start to backfill. PB is pretty busy, has several going on at the same time. Electrician comes tomorrow to run conduit for future lights and electrical needs.
 
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.