Finally started!!!!!

Carnut12

LifeTime Supporter
Jun 2, 2013
324
Forsyth, GA
After 2 years of debating getting a pool we finally took the plunge. We started this process 2 years ago, but potential relocations at work delayed it. This year I decided I can't just keep waiting thinking we might relocate, we will cross that bridge if and/or when we get there.

Here are the pool specs-
24'x44' Freeform
Deep End poured concrete Bench
Poured Concrete Steps
Cantilever Edge with stamped border
Unilock Brussels Paver Decking in Sierra, around 1400 Sq Ft
Unilock Brussels Dimensional retaining wall
2 laminar jets
Gerano liner from GLI
Intellitouch 8 with Screen Logic

All Sta-Rite Equipment-
450 Sq Ft Cartridge Filter
400K Natural Gas Heater
Salt Generator
Intellipro Supermax VS Pump

I am sure I missed a few things

Here are a few pictures so far- by the way these pics are taken from the deck off my bedroom, going to be a great view.
20krpzl.jpg


wkjqcn.jpg


35jgl7n.jpg


Everything look OK so far????
 

Carnut12

LifeTime Supporter
Jun 2, 2013
324
Forsyth, GA
It's a liner pool with Polymer walls, based on going with Salt I preferred Poly, but I was not anti-steel. I honestly ended up picking the PB I wanted regardless of what type they used.

- - - Updated - - -

This is the manufacturer I went with-

http://www.imperialpools.com/products/polymer-pools
 

doobs41378

Well-known member
Mar 8, 2013
362
New Hampshire
Wow that`s a huge pool. Going to look great when done. Keep the pictures coming. Good to see another liner pool on here. I was getting lonely. lol

No need to be lonely...there are plenty of us on here...What you should be more surprised about is they are not from TX, where everybody seems to be from that is on here.... OP great looking start, will be watching.
 

Enjoying this content?

Support TFP with a donation.

Give Support
Thread Status
Hello , This is an inactive thread. Any new postings here are unlikely to be seen or responded to by other members. You will get much more visibility by Starting A New Thread