Does Vinegar Damage Jandy AquaPure Sensors?

crystallake

New member
Sep 30, 2020
1
Los Angeles CA
Pool Size
16000
Surface
Plaster
Chlorine
Salt Water Generator
SWG Type
Jandy Aquapure 700
Hello all. Today I completed my first cleaning of my Jandy PLC700 SWCG in response to error code 120. When looking through various tutorials I decided to go with the less corrosive vinegar route, but I did not remove the sensor from the side port of the unit. I didn't realize until after soaking for a few hours that it should have been removed. The manual states that it needs to be removed when doing an acid cleaning, but did I do significant damage by keeping it on and soaking it in vinegar for a few hours? I resolved the error code issue after reconnecting so it appears to be working fine, but I am just curious if I may have done something to potentially shorten the life of the sensor.

Thanks.
 
Thread Status
Hello , This is an inactive thread. Any new postings here are unlikely to be seen or responded to by other members. You will get much more visibility by Starting A New Thread