Bullfrog plug and play 120v to 240v

[Buckman1981]

Hi, I really want to convert my bullfrog that was converted to 120v at the factory back to 240v. I understand to unplug the jumper wire between j35 and j64 and where the 240v wires go, but right now the only dip switch that is "on" is #4. I don't know how to set the dip switches back for 240v? Anyone that can help me would be awesome! Thank you

 

[cowboycasey]

I am not sure but lets see if @RDspaguy knows

 

[RDspaguy]

Dipswitch A2 on as well as A4. This will allow the heater to run with the jets on high. I assume you are on a 50 amp breaker? It may trip the breaker if not.
By removing the jumper and wiring up 240v you have already converted the heater.
Post a picture of the circuit board so I can verify pump wiring.

 

[Buckman1981]

Dipswitch A2 on as well as A4. This will allow the heater to run with the jets on high. I assume you are on a 50 amp breaker? It may trip the breaker if not.
By removing the jumper and wiring up 240v you have already converted the heater.
Post a picture of the circuit board so I can verify pump wiring.

Omg, thank you so much! I will get a pic of the board. You are talking about the actual board itself right, not the pic of the diagram on the cover I posted above?

 

[RDspaguy]

Yes, the circuit board.

 

[Buckman1981]

I have it running on 120v currently. Here is the circuit board, and thanks again! I also took two close up shots.

 

[RDspaguy]

Pump wiring is correct.

 

[Buckman1981]

I am not sure but lets see if @RDspaguy knows

Thanks for the referral, he must really know his stuff!

 

[cowboycasey]

Ohhh HE DOES

 

[RDspaguy]

Thanks for the referral, he must really know his stuff!

Ohhh HE DOES

Shhhh!!! Not so loud! I have a reputation, you know...