The connector on my AquaRite T15 salt cell to the AquaRite controller has connection issues, looks like some corrosion inside the connector. What's the best way to clean inside to make sure it makes contact? As long as I press the connector in and get it making contact the SWG system works, otherwise it can't read the salt levels/turn on the cell. The cell has barely been used but was in storage for a while, and some water may have gotten into the connector. Thanks for any ideas!
AquaRite salt cell connector cleaning
- Thread starter rynoshark
- Start date
- May 3, 2014
- 58,303
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Hayward Aquarite SWG - Further Reading
www.troublefreepool.com
I had pretty good luck with them so far.
DeoxIT D-Series page with shop - CAIG
DeoxIT® D-Series contact cleaner dissolves oxides and sulfides that form on metal surfaces. This restores the contact’s integrity and leaves a thin microscopic layer that protects the metal. Special additives improve conductivity and prevent dissolved oxides from re-attaching, keeping them in...
caig.com