I just installed a new AquaRite Goldline with a T Cell 15 SWG. I’ve noticed that the panel will say that it is generating, but when I check the instant salt reading, it will say -0 as if it’s not generating. There are no error lights on the panel either. Is this normal? Does the cell turn it self on and off to hit a certain percentage? I have the cell turned to 50%. I can also flip the cell from on to off and it will then give me instant readings again.
AquaRite Goldline with a T Cell 15 SWG Instant Salt Level
- Thread starter rockylreed
- Start date
- May 3, 2014
- 58,370
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
At 50%, the cell is on half the time. Even when not really generating, the Generating light stays on.
So you are getting the -0 during the time it is not generating.
So you are getting the -0 during the time it is not generating.
Runs on a 3 hour cycle I think. So at 50% it will run for 90 minutes and then not generate for 90 minutes.
Similar threads
