aquarite board measures too high at leads

farrarcw

New member
Sep 6, 2013
1
#1
I am having various issues with my Aquarite salt system.
I changed the main board, then the flow sensor went out.
I changed the flow sensor, and then board wouldnt work correctly.
I had an old board, so I replaced the board to see if behaved the same, it did.
So I put the new board back, and found something on the web that stated voltage across the two leads should be between 209 and 241, mine measures 253. When i put the new board back in, almost immedately two components burned.
I am wondering this has to do with the voltage measured across the leads, and if so, what i can do to fix this.
 

chem geek

TFP Expert
LifeTime Supporter
Mar 28, 2007
12,082
San Rafael, CA USA
#2
Welcome to TFP! :wave:

I know this is an older post and no one answered it, but wanted to encourage you to continue to post and ask questions. Not every question gets an answer, but we should have at least welcomed you to the forum.