Aqualogic Board Replacement - No Menu

rodx4

Member
May 23, 2008
23
Stafford, VA
Hello All,

I just swapped out my Aqualogic board. Everything is hooked up, turn it on and the display lights up. Unfortunately, I cannot access any of the menus to program. No buttons work. The only items showing on the display are temp, salt, time, date. Hope the rebuilt board is good. The tech is out till tomorrow, so no phone support. Any ideas?
 

ajw22

Gold Supporter
TFP Guide
Jul 21, 2013
28,003
Northern NJ
Pool Size
35000
Surface
Plaster
Chlorine
Salt Water Generator
SWG Type
Pentair Intellichlor IC-60
Check that the display board is properly seated on the main board.

Post pics of the insides of the unit showing the boards.

@JamesW may have ideas.
 

rodx4

Member
May 23, 2008
23
Stafford, VA
I called the tech and he couldn't figure it out either. He thinks the new board may be bad and is shipping one out, today. I put the old board back and I can access the menu again. Thanks for the replies.
 
Thread Status
Hello , There was no answer in this thread for more than 60 days.
It can take a long time to get an up-to-date response or contact with relevant users.