2 out of 4 jets work great, one ok and one is lame.

[NorthOfDallas]

Hey folks! I have an inground spa that runs off of my 1.5 HP pump with no booster. As you can see in the below pics, jet 1 from the left does great, Jet 2 is barely anything,jet 3 is very good and jet 4 is kind of weak. I'm not sure where to start but I'm pretty handy and sorta smart. What say you, oracle of aqua?

Sent from my iPhone using Tapatalk

 

[Richard320]

In years past I know someone used a deep 14mm socket to unscrew the jets and found some plaster chunks left over from construction had migrated down the plumbing far enough to block flow. You might check to see if you have the same style jets.

 

[NorthOfDallas]

Richard, YOU ARE THE MAN!!!! These two jets have been a know issue for the 2.5 years I've been here and for years before that from the previous owner. I can't wait to tell him I fixed it (with your guidance of course) in 5 minutes. There was a couple of pieces of plastic in them. I'm scared to think of the origin, but oh well. BTW, mine were 13mm nozzles.

If you ever make it to Dallas, the bar tab is on me!

Sent from my iPhone using Tapatalk

 

[poolnoob.ca]

Good job! That was a quick TFP fix!

 

[Richard320]

I knew I was good for something. No matter what everyone says.