I cannot seem to get my omnilogic and heater to communicate, which I imagine is in the settings of the Heater. Does anyone have any experience with getting the two to communicate so i can adjust the temperature from Omnilogic? Thanks!
Omnilogic and Heatpro 21404T
- Thread starter bobby299
- Start date
Sorry for the lack of response, but I have no help either.
Have you read the heater manual about how to use an external controller?
Have you read the heater manual about how to use an external controller?
Jason thanks for the reply. I did get it fixed this morning after talking with Hayward I needed to delete the heater from omnilogic and reconfigure it. Works fine now!!! Thank you
Hold "set" button on heater for about 5 seconds until you see "Loc"
Then press the up arrow button until you reach 50 degrees
Set pool temp to off
Set spa temp to 104
Scroll "set" button til u get to the P_S section, then arrow til you get to "E"
That should put it in bypass mode
Hold "set" button on heater for about 5 seconds until you see "Loc"
Then press the up arrow button until you reach 50 degrees
Set pool temp to off
Set spa temp to 104
Scroll "set" button til u get to the P_S section, then arrow til you get to "E"
That should put it in bypass mode
