Pump Not Going Into Standby Mode

[csm]

Pump/filter has been working fine until just recently. Now it will not shut down. I am doing nothing different though we have had a few storms and the pump has had to be reprogrammed a few times. I follow the steps in my manual as follows:
Turn on power switch
00 appears flashing
I set hours to 6
Pump runs required amount of hours
Sleep light comes on but the pump never stops running
I have turned it off manually several hours later (3) or the next day.
Pressing a button to see code during this time I see 93
I have shut the pump off and reprogrammed the pump several times, varied the hours, unplugged the unit, still the pump never quits after the hourly countdown.
Is there a reset button somewhere? Thoughts?

 

[Azgirl71]

Code 93 will show up during the shutdown process. Usually with shut down with in the hour after you see code 93.

 

[bobodaclown]

Have you checked Intex web site: Support - Intex

 

[csm]

Code 93 will show up during the shutdown process. Usually with shut down with in the hour after you see code 93.

Yes but it never shuts down. I had to turn it off this morning after it ran all night. Was programed to run 1 hour as a test to see if it would shut down after unplugging.

 

[Azgirl71]

That is strange. Soundalike theming is defective. I would call the customer service number for Intex if it is less than 1 year old.

 

[csm]

That is strange. Soundalike theming is defective. I would call the customer service number for Intex if it is less than 1 year old.

Called Intex and they are going to replace the pump motor as it is bad according to them. I do not know if this is really the problem but I will see if it works!

 

[Azgirl71]

Glad they will be replacing it. I would guess there could be some sort of short in it making to not communicate as it should.