Hi -- I added 160lbs of salt to my pool and suddenly the red high salt light appears. Before this it said check cell and no salt reading. I did that (cleaned cell) and then thought I should add salt since it was the first time i added it since June of last year. How do I get this corrected?
Salt too High
- Thread starter Elvis2009
- Start date
Welcome to TFP!
You should turn off the SWG for 24 hours after adding salt, leave the pump running for those 24 hours, and then turn the SWG back on and let it measure the salt level to see what it is.
Salt levels in the first 24 hours will fluctuate wildly as the salt mixes into the pool water.
You should turn off the SWG for 24 hours after adding salt, leave the pump running for those 24 hours, and then turn the SWG back on and let it measure the salt level to see what it is.
Salt levels in the first 24 hours will fluctuate wildly as the salt mixes into the pool water.
- May 22, 2013
- 2,796
- Pool Size
- 12000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Hayward Aqua Rite (T-15)
Welcome to the forum Elvis 
Please add your pools info into your signature and outlined here - - > http://www.troublefreepool.com/content/165-getting-started
Need the information that would be in your signature to answer the question.
Please add your pools info into your signature and outlined here - - > http://www.troublefreepool.com/content/165-getting-started
Need the information that would be in your signature to answer the question.
Similar threads
