Alright, I have soldered the K1 twice and it worked for a short while. Any other suggestions? Would the change to a 15 amp fuse help? What are the normal readings for amps and volts?
Aqua Logic Problems
- Thread starter mpowered
- Start date
I tried the 15 amp fuse and still get a high amps/salt reading. I have tried 3 different salt chlorinators and get the same error message. I may just go to a chlorine pool.
- May 3, 2007
- 16,828
- Pool Size
- 20000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Hayward Aqua Rite (T-15)
Or a salt level that is too high. What are the Volts and Amps reading right before it alarms. You can use the + button while in diagnostics mode to reset the unit. Normal ranges are 24-26v and 3-8 amps. Above 8 amps and the unit will alarm.
Make sure that the correct cell type is selected in the menu.
Also, high water temperature, especially if the cell is after a heater, can sometimes cause a high salt/amps fault.
Also, high water temperature, especially if the cell is after a heater, can sometimes cause a high salt/amps fault.
Similar threads
