Aquarite T3 diagnostics - no amps or current reading

[Broehn]

I have an aqua rite T3 SWG. It has not been producing chlorine for a few days. I had the cell tested at the local pool store and it fine.

I was given a set of readings to compare for the diagnostics. I have a 0 reading for my #3 reading which I was told was the amps and a 0 reading for my #4 reading which I was told was volts.

Before I replace the board, is there anyway to just replace a piece on the board? Is there any way to reset the board?

Any help with this will be greatly appreciated.

 

[robl45]

No current and no volts sounds like the transformer is bad.

 

[JasonLion]

Take a look at this topic. There are several good suggestions in there. One common issues is a burned out current limiter that can be replaced easily if you are handy with a soldering iron.

 

[Broehn]

Jason,

Thanks for directing me to the posts on the current limiter. I ordered from digikey and was able to replace the piece. I found that CL was cracked at one of the legs.

I also found it out how poor my soldering skills were.

My cell is currently producing now.

Thanks again for the help.

 

[Divin Dave]